• Low fuming — minimal emissions 
• Special organic binders — reduce flux chipping or peeling 
• Free machining 
• Superior strength 
• Resists corrosion 
• Cadmium free

SPECIFICATIONS

• Joint strength: 67,000 psi/462 MPa
• Plastic range: 35°F/19°C
• Working temperature: 1620°F/882°C
• Electrical conductivity: 24% IACS
• Flux coating color: Green
• Machinability: Excellent

PROCEDURES
For Brazing:
Adequately preclean the weld area. For best results, parts will require minimum joint clearance. Use a neutral flame to heat the base metal to a dull red. Melt off a small amount of rod and flux, allowing thin deposits to flow through the joint. Add additional filler metal as needed. Let the completed joint cool at room temperature.

For Buildup and Overlaying:
If thick sections are to be overlaid, preheating may be needed. Preheat the starting area to a dull red. Apply filler metal in small deposits and wet out on the base metal in a tinning fashion. Apply successive layers of filler metal until the desired buildup is obtained.